COMBI Calibration Master and Depth Calibration Procedure 螺纹深度塞规校准
Leitech's inch or metric Calibration Masters make it easy to reset the specified calibration length after changing or replacing gaging members on any size COMBI Gage currently manufactured. 1. Dial in the required thread pitch on the Master to establish the specified calibration length. 2. Loosen the two locking set screws (A) on the COMBI Handle. 3. Place the gage in the appropriate size hole in the Master. 4. Turn the NOT GO end in either direction to set the COMBI Gage measuring scale on the sleeve to either the .400 line for the inch model, or the 10,0 mm line on the metric. 5. Re-tighten the locking screws. Your COMBI Gage is now set at the correct calibration value for accurate functional thread depth measurement. This fast and foolproof method eliminates the need for a vernier caliper, depth micrometer, or gage blocks. Note: Common size nuts available from customer inventories are tightened against the removal sleeve (similar to a jam nut) to remove the taperlock member from the Leitech handle. |
 |
2013年4月25日 13:18
ꄘ浏览量：0
